Gain reduction is nearly instantaneous for both expected and severe input overloads. The HR-MCP2 is designed to hold average output levels constant without altering the sonic integrity of dynamic sources. A front-panel switch is provided to enable 48 Vdc phantom to both microphone inputs. The HR-MCP2 is compatible with dynamic and condenser microphones.
The unique circuit design preserves full studio-quality low-noise performance at any gain setting.
Each channel can therefore be used as a mic-level in-line compressor or as a microphone preamplifier with compression. Rear-panel switches allow setting each output to mic or line level. The HR-MCP2 is a dual channel microphone compressor that produces a consistent audio output level over wide variations (up to 25 dB) in the microphone input level. Once again, you could have alternatively dragged and dropped the instruction into the program window.Product Description RDL HR-MCP2 Dual Microphone Compressor Overview Note that the new XIC instruction is now selected (highlighted). Now click on the XIC instruction with your left mouse button (Left Click) and it will be added to the right of your highlighted selection. Alternatively you could have dragged (left mouse button held down) the Rung button into the program window and dropped it onto one of the locating boxes that would have appeared. Note that the new Rung was inserted above the existing (END) End Of Program Rung. You should now see a new Rung added to your program as shown above, and the Rung number at the left side of the new rung should be highlighted. If you hold the mousepointer over any of these buttons for a second or two, you should see a short "ToolTip" which describes the function or name of the instruction that the button represents. It's the first button on the very left end of the Bar. First click on the "New Rung" button in the User Instruction Bar.
0 kommentar(er)
